Pipe burnt ?

Log in

SmokingPipes.com Updates

Watch for Updates Twice a Week

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

Cptsmoker

Lurker
Oct 17, 2024
2
0
Greetings all ,
Nice to be meeting ya all ,
Purchased and smoked this beauty after the first smoke the finish became like this any ideas on how to repair it ? (Never smoked the pipe too hot) .Referring to the white mark on the exterior
Can i repair it somehow Or should i ask for a replacement ?
 

Attachments

  • IMG_20241022_204333.jpg
    IMG_20241022_204333.jpg
    51.8 KB · Views: 68

Chasing Embers

Captain of the Black Frigate
Nov 12, 2014
45,294
119,464
Looks like it had some sort of lacquer or varnish on it a a piece of it flaked off. Personally I'd remove the rest of it with acetone and wipe the stummel down with mineral oil.
 

Hillcrest

Lifer
Dec 3, 2021
3,805
19,347
Connecticut, USA
Which white mark, there appear to be several ? The right and shank look like reflection, the lower left pink area looks like a varnish chip, the center white line looks like reflection, the cloudy area from top of bowl to center looks like some moisture got under the wax and if so can be removed with a cloth or paper towel dampened with rubbing alcohol and laid on top of it for a few minutes at a time. If condensation gets under wax on wood it leaves that kind of ghostly gray area. It may indicate a pinhole in the briar or a birdseye that is leaking steam when you smoke and you may have to use a little wood filler to seal it then sand and refinish. So best case to worst case. What kind of pipe ? possibly return it to seller for replacement.
 

Chasing Embers

Captain of the Black Frigate
Nov 12, 2014
45,294
119,464
That's pretty serious solvent for a pipe.
Not at all, it removes the lacquer but not the stain. I did this same to this old Big Ben some years ago.

20241022_173837.jpg

Some restoration folks such as SPC even use denatured alcohol to clean and sanitize estates. The acetone just removes the lacquer or clear coats used on some pipes.
 
  • Like
Reactions: pipenschmoeker123

Some Joe Blow

Lurker
Oct 28, 2024
33
79
Northeastern Ohio
I have similar issue with mine, I might try the acetone and refinish with mineral oil.

I also think the issue with mine is it was a cheaper quality pipe. Not saying that's the case though for you.