Pipe cleaners doesn't reach to the end of the stem

Log in

SmokingPipes.com Updates

Watch for Updates Twice a Week

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

Drucquers Banner

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

Dmitri1516

Might Stick Around
Jul 7, 2022
90
44
Hi guys, may I know if it's okay if the pipe cleaner doesn't reach to the end of the stem when cleaning ? Like when I clean my pipe stem, the pipe cleaner doesn't go all the way to the end of the stem ?
Thanks
 
  • Like
Reactions: Briar Lee
Dec 3, 2021
6,364
56,815
Pennsylvania & New York
There is a slight problem tho. The pipe cleaner cannot go through from the mouthpiece end
Falcon pipe cleaners are thinner than most others. They might fit a narrower draught hole. Sometimes a bend in the stem is too severe for a cleaner to make it through. As suggested above, going at it from both ends may be necessary. You can slightly curl the end of the pipe cleaner to help facilitate it getting past a sharp curve. Good luck!
 

Streeper541

Lifer
Jun 16, 2021
3,286
20,660
45
Spencer, OH
Silly question, but are you putting the pipe cleaner in from the correct side of the stem?

Quite often I find it's more difficult to pass a pipe cleaner from the right, where the button is located.
20221204_134550.jpg20221204_134614.jpg

Most times I have very little difficulty passing a pipe cleaner from the bowl. As you can see in the illustrations below.

20221204_134521.jpg20221204_134633.jpg

Same, standard sized Dill's pipe cleaner used throughout. Just barely makes it when I pass via the bowl side.
 

Dmitri1516

Might Stick Around
Jul 7, 2022
90
44
I tried using the soft pipe cleaner to clean first then use the hard one next but still cannot go all the way. Is there any way to unblock the blockage ?