I figured I'd share the step by step on filling in tooth chatter that that wouldn't go away with a lighter.
First you need some stems in rough shape
I gave these a light sand to make sure there wasn't much oxidation before the super glue.
I then added the black super glue to some activated charcoal. I went with a capsuled version hoping it would be fine and it was.
Mixed it with the glue
Then applied. This is where I think I made a mistake. I applied quite roughly and I think it carried to the end result.
I let them dry.
And you can see that it is quite rough below
I then used 220 sandpaper to shape the rough glue and moved up to through 400, 800, 1000, and the micromesh set.
First you need some stems in rough shape
I gave these a light sand to make sure there wasn't much oxidation before the super glue.
I then added the black super glue to some activated charcoal. I went with a capsuled version hoping it would be fine and it was.
Mixed it with the glue
Then applied. This is where I think I made a mistake. I applied quite roughly and I think it carried to the end result.
I let them dry.
And you can see that it is quite rough below
I then used 220 sandpaper to shape the rough glue and moved up to through 400, 800, 1000, and the micromesh set.