emery board a stem?

Log in

SmokingPipes.com Updates

Watch for Updates Twice a Week

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

Drucquers Banner

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

Status
Not open for further replies.

alexnc

Part of the Furniture Now
Oct 25, 2015
953
812
Southeast US
I never clinch - but then I was driving with a small Dunhill and put a light chatter mark on the stem just above the button. Very light. Would an emery board be a bad idea? I've never tinkered with a stem before. Thx

 

hmhaines

Part of the Furniture Now
Sep 5, 2016
900
1
CT
Emery board is going to roughen up the stem quite a bit. I'd poke around the forum a bit, there's plenty of great information on stem restoration here.
Is it Vulcanite or Acrylic?

 

pagan

Lifer
May 6, 2016
5,963
28
West Texas
I use 2000 or finer sand paper on badly chattered stems, emery paper might do as well, if its not that bad try micromesh or a magic eraser, takes a while and elbow grease but you don't want to take off to much

 

zack24

Lifer
May 11, 2013
1,726
2
Don't use an abrasive...check out this link on using heat and it should solve the problem...
http://rebornpipes.wordpress.com/2012/06/09/lifting-tooth-marks-in-an-old-charatan-stem-with-a-heat-gun-4-2/

 
Jan 4, 2015
1,858
11
Massachusetts
Zack is right on with his advice. Some sanding will be required but I don't recommend using an emery board, it's way too aggressive. Depending on how glossy you want the rejuvenated bit to be will dictate how fine a paper you use. Micro mesh pads are relatively inexpensive and a good investment for this kind of work. They're available on Ebay for short money.

 

alexnc

Part of the Furniture Now
Oct 25, 2015
953
812
Southeast US
Thank you Zack, that was excellent advice. The mark was very light - a one time thing (I bought some softy pipe bits that day!). No sanding and just a bit of heat over a gas stove burner - the smallest one. Felt with my hands to find the hot spot and gauge the distance. Came right out. I didn't realize how soft the stems are. Sorry - no pics. I don't think most people would have done anything it was so small, pics would have been really boring!

 

clickklick

Lifer
May 5, 2014
1,699
211
That is the noted difference between a dent, where material gets pushed in but not removed . . . and a scratch, where material is removed and leaves the groove.
For dents, always default to the heat method! Although you may lose some luster, it is much easier to reobtain luster than it ever will be to reobtain material!

 

mkelaw

Starting to Get Obsessed
Aug 30, 2012
121
56
I'd also recommend against an old fashioned emery board. They're very coarse. Simple chatter should come out with 400 sandpaper followed by 600. Or, you can get some foam nail boards at Walgreens in various grits, some very fine. Don't use any abrasive unless you have a buffing wheel to remove the scratches and restore the shine to the stem.

 
Status
Not open for further replies.