Adjusting Stem Fit

[Brig]

Good evening!

Just got this little estate Austrian meer in, nice and small and figure it'll be a good pipe for a quick smoke or for sampling new tobaccos.

Bowl itself is light as a ping pong ball. Only trouble is, the stem is slightly skewed to the side.

I suspect that this may have been the case in production, as it is not loose and the case seems to have wear consistent with the skew.

Not really a huge deal, I suppose, but I'd kind of like it to be straight. Any tips on adjusting stem fit, or would I have to have a new stem made completely to get it straight and snug?

 

[Chasing Embers]

What kind of tenon does it have?

 

[Brig]

What kind of tenon does it have?

 

[Chasing Embers]

View attachment 321717

Appears to be bone.

correcting an over clocked bone tenon – rebornpipes

Posts about correcting an over clocked bone tenon written by rebornpipes

rebornpipes.com

 

[Brig]

Interesting. Might have to try the superglue technique, though I'm kind of afraid to overgunk it up

 

[AJL67]

Yah that is a problem with estate meers, i've learned to stay away from older pipees with screw in tenon, gotten a few overclock and usually on the "sultan" style carved pipes.

 

[OzPiper]

Overclocking
You could try painting a thin layer of clear nail varnish on the tenon
Or using a piece of felt/leather "O ring" between the stem and shank

 

[jpmcwjr]

Overclocking
You could try painting a thin layer of clear nail varnish on the tenon
Or using a piece of felt/leather "O ring" between the stem and shank

I used paper for a small adjustment. Dental floss, too.

 

[jhowell]

Hole reinforcers for notebook paper - they come in paper and mylar giving you two different thicknesses of shim...

 

[Brig]

Hole reinforcers for notebook paper - they come in paper and mylar giving you two different thicknesses of shim...

This stem is far too narrow for those, unfortunately.

Might try the dental floss solution first.

 

[Searock Fan]

From the pic it looks like the stem is turning a little too much. No problem, just take a piece of sticky tape, put a hole in it the size of the tenon, slip it over the tenon sticky side down and press it against the flat part of the stem. Screw in stem and repeat if needed. When it fits right, trim the tape and you're done. Basically, you've created a "spacer".

 

[craig61a]