Standard Terms to Describe Amount of Bend?

Log in

SmokingPipes.com Updates

New Cigars
12 Fresh Bruno Nuttens Pipes
3 Fresh G. Penzo Pipes
36 Fresh Erik Stokkebye 4th Generation Pipes
2 Fresh IMP Meerschaum Pipes

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

Drucquers Banner

PipesMagazine Approved Sponsor

geopiper

Can't Leave
Jan 9, 2019
403
660
Are there standard terms to describe the amount of bend in a pipe shank? How would you describe to an artisan pipe carver how much bend you'd like in a pipe your commissioning from them?

I've heard straight, quarter bent, half bent, three-quarter bent, full bent. Assume a straight pipe has no bend and is pointing straight out from your face when clenched in your teeth. To me this is 0-degrees relative to horizontal (think straight billiard) . Assume a full bent pipe is pointing straight down from your face when clenched in your teeth. To me this is 90-degrees relative to horizontal (think oom paul). With these two extreme cases in mind, a quarter bent would have a 22.5-degree angle, a half bent would have a 45-degree angle, and a three-quarter bent would have a 67.5 degree angle.
 
  • Like
Reactions: ofafeather

cigrmaster

Lifer
May 26, 2012
20,248
56,848
67
Sarasota Florida
The quarter bent, half bent, three-quarter bent, full bent all work for me. I have no full bents anymore and only a couple 3/4, couple of half bents and a couple of quarter bents. Most of my pipes are straight as that is the look I prefer. I have no idea why I like straight so much. One day I might figure it out.

I just took a look at my collection and I have more 1/4 bents than any other bent pipe.
 
  • Like
Reactions: CoffeeAndBourbon