Savinelli 320 Pipe Filters?

Log in

SmokingPipes.com Updates

Watch for Updates Twice a Week

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

zfierstadt

Lurker
May 17, 2025
4
0
Title was corrected -Rule #9, Title Capitalization
I recently bought a Savinelli 320 and standard pipe filters don't pass through the bit (filter removed).

How do you clean it? Ultra thin Falcon filters?
 

OzPiper

Lifer
Nov 30, 2020
7,541
41,827
72
Sydney, Australia
It's a bent pipe. You might have to bend the end of the cleaner slightly, so that it follows the contour of the bit.
I have old pipes with narrow airways or small bone tenons
I use the thin Falcon cleaners or in the case of very narrow airways, then I use the coloured cleaners found in craft supply shops.

If the stem is bent, putting a small bend in the end of the cleaner may help.
You may have to wiggle the cleaner to get it through the mortise and shank.

Not all bent pipes will pass a cleaner despite your best efforts.
You may have to dissemble the pipe to clean out the mortise and shank.
 

Hillcrest

Lifer
Dec 3, 2021
4,356
23,041
Connecticut, USA
I sometimes have this problem with P-Lip stems and Savinelli Dry System stems. You have to hold the cleaner close to the stem opening and try to inch it in. It usually starts to bend about an inch in and you can't go any further so I then clean the rest of the stem from the other end. Run water through the stem first it seems to clean better for me. just 2 cents.
 
  • Like
Reactions: ThermionicScott