Corn Cob Mods?

Log in

SmokingPipes.com Updates

Watch for Updates Twice a Week

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

Drucquers Banner

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

Status
Not open for further replies.

cacooper

Starting to Get Obsessed
Jul 28, 2009
224
72
Parker, CO
I always wanted a full bent cob. MM doesn’t make such a deep bend. So, I take a Country Gentleman, cut off the shank, bore a 1/2” dia. hole at a 45 deg. angle on my lathe with a milling attachment for a new shank that I also turned on my lathe. This one is zebra wood. I then fit the standard stem w/filter, standard trim ring, then heat it with a heat gun to a graceful bend. I’ve made a couple and they smoke very nice.
9405
 
Status
Not open for further replies.