Cleaning up an eBay pipe (w/pics)

Log in

SmokingPipes.com Updates

Watch for Updates Twice a Week

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

PipesMagazine Approved Sponsor

Status
Not open for further replies.

cynyr

Part of the Furniture Now
Feb 12, 2012
723
1,718
Tennessee
A couple months back, I scored a Brewster off eBay for five bucks. Research on this forum and the wild, untamed internet tells me the Brewster pipes were all made in one batch in 1964 as a promotional item for Sir Walter Raleigh. Since that's the year I was born, this pipe and I get along very well, and it does deliver a good, sweet experience.
When I got this pipe it was pretty crusty and green, so I cleaned it up some - and when it's winning disposition shone thru I decided to give it a thorough cleaning. Here are the pics:
img_0042-600x450.jpg


Brewster's rim is a little wavy and funky. I dig that. You can see better in this After pic:
img_0048-600x450.jpg


It kinda slopes inward, and has a sort of wave to it. Interesting.
img_0036-600x450.jpg


The stem was brown and green in spots.
img_0058-600x450.jpg


But using techniques I learned from you gentlemen, it's clean and black.
img_0050-600x450.jpg


Another shot of the rim, showing the grain.
img_0051-600x450.jpg


And he does have some nice grain, with flame on both sides - a bit of bird's eye fore and aft.
img_0046-600x450.jpg


This before picture shows the stamp and some of the stem grunginess.
It's still got a few dings, but as I learn, I'll take care of them, too. Thanks for looking!

 

spartan

Lifer
Aug 14, 2011
2,963
7
Nice clean up job!
I still have 4 pipes I got off the bay that I need to clean but I havn't gotten off my butt and bought some micro mesh yet so I'm waiting until I have everything I need before I get started.
A good looking pipe. Very Old-timey lol

 

cynyr

Part of the Furniture Now
Feb 12, 2012
723
1,718
Tennessee
I did the stem with Barkeeper's Friend (thanks to shaintiques) and rubbed hell out it. The briar I did with a quick application of BF and a fast wipe, just to cut the nastiness. I didn't know what Barkeeper's would do to wood, but was willing to risk a little.
Most of it was just hard work, honestly. Still a few dings, as you can see, and I added another ding this morning. Eventually, I'm going to do the sanding and Micromesh - I can see the lines from the lathe - but that's in the future.

 

steyrshrek

Starting to Get Obsessed
Apr 1, 2012
252
1
If the dings aren't too deep try a steam iron, Just hold the pipe in the stream of steam should pop the dings right out.

 
Status
Not open for further replies.