By Bob Tate

packing

[Editors Note: Be sure to read Part Two of this article, Tobacco Pipe Packing Methods - Part 2 (With Videos), to see instructional videos on how to perform these methods.]

There are a lot of different ways to load your pipe for smoking. Here I will list a few different methods that I know of and give a brief description of them. Remember that there is no exact set of rules for packing your bowl. The goal in packing your pipe is to get a proper draw, it doesn’t matter how or which method you use to do it. The most commonly accepted draw should feel like you are drinking through a straw. When it feels like that, you should not have any problems. I prefer my draw to be a little looser than that.

I don’t use any one method exclusively and quite often, I hybridize the methods that I know to create ones that work for me at a particular time, situation, or certain pipe. Another thing to remember is that it is easier to tighten up the tobacco while smoking than it is to loosen it up. That is why I always tend to pack looser and adjust the tightness of the tobacco, if needed, by tamping during the smoke. Now onto the methods!

1) The Stuff and Puff Method - The stuff and puff method seems to be used by the older more experienced pipers. After years of experience, they have acquired the ability to stick their pipe into a pouch or jar of tobacco and fill it by scooping the tobacco into the bowl with their finger and knowing when they have the right amount of pressure applied for a proper draw. This is done all in one step. When they pull the pipe out, they light it.

2) The Three Step Method – This method is the most taught to and most used method by beginning pipers. It consists of; you guessed it, three steps. The key to this method is using small pinches of tobacco.

The first pinch of tobacco should be very small and placed in the heel of the bowl and applied with very little or no pressure at all.
The second step is a slightly larger pinch of tobacco. The pinch is put into the bowl and a little pressure is applied pushing the tobacco to the half way point in the bowl.
The third step is placing another pinch of tobacco in the bowl and using a little more pressure, pushing the tobacco down leaving a space of about 1/4 of an inch from the rim.

The amount of pressure used for each step is commonly described as; the first pinch should be done with the pressure of a child, the second pinch with the pressure of a woman, and the third pinch with the pressure of a man.

3) The Frank Method – The Frank method was invented by Mr. Achim Frank and is a very hard method to describe. You want to gravity fill the bowl to the top and the work in a large portion of tobacco on top of it. Kind of like a plug. It is easier to just watch the video to see how this is done and what to do. You can see the video of it here: Tobacco Pipe Packing Methods Part 2 (Videos)

Although Mr. Frank uses a torch lighter and recommends using one, I do not recommend it. The reason why I do not recommend it is that a torch lighter can seriously burn the rim of your pipe beyond repair. If you do use a torch lighter with this method, be careful and be warned of the damage that can occur if you are not careful.

4) The Air Pocket Method – This method was brought to the main stream by Fred Hanna. I read about this method in an article that Mr. Hanna wrote for the 2007 Winter Edition of Pipes and Tobaccos Magazine. This method leaves the bottom of the bowl empty which creates an air pocket, hence the name. I am going to paraphrase the steps from memory.

Grab a large chunk of tobacco and squeeze it into a clump using your thumb and first three fingers.
Shove the clump of tobacco into the upper half of the bowl leaving the bottom half of the bowl empty.
Force the tobacco into the bowl tightly but do not use excessive muscle to do so.
While you are shoving the tobacco into the bowl, start twisting the chunk of tobacco into the bowl so that you are screwing it into the bowl.
Screw the clump down deep enough into the bowl so that you will not damage the rim when you light the tobacco.
Make sure that you do not push on the center of the tobacco.
Remember that there should be no tobacco in the bottom of the bowl.
Test the draw. If it is too tight, empty the bowl and start over.
Light only the center of the tobacco making sure that you get it good and lit. The tobacco will burn outwards towards the walls of the bowl once it is lit.

5) The Two Step Method – This is one of the hybrid methods that I was talking about. I don’t want to say that I created it because I am not sure if others have used it before I started doing it. It is like the three step method but with the first step omitted.

I gravity fill the bowl and lightly push it to the half way point of the bowl.
I finish filling the bowl and lightly push it down to about 1/8 to 1/4 inch from the rim.

99% of the time I get a perfect draw on the first try.

6) A Hybrid Method (The Bob Method) – I do not know what to call this method. It is a hybrid method that I started doing a few years ago. I don’t think that anyone uses it. But as in the two step method, I don’t want to say that I created it because I don’t know if anyone has used it before me. I combined parts of the Frank method and parts of the Air Pocket method to create this. This is what I do:

I skip the first step of the Frank method and leave the bottom of the bowl empty so that there is an air pocket (like in the air pocket method).
Then I grab a large chunk of tobacco and work it into the bowl exactly like the second step of the Frank method (I do not screw it in like the Air Pocket, I use my thumbs like in the Frank method).

This method works great when smoking a pipe that has a ‘well’ in it. Since there is no tobacco in the bottom of the bowl, it does not allow the moisture to collect in tobacco that is in the ‘well’ causing a large amount of dottle.

You do not have to stick to just one method of packing and as you can see from the last two methods, combining or trying out something of your own can help you out in packing a pipe. Try out new and different ways of packing until you find out some that work easily for you. Remember, what works for some people might not work for others. Keep experimenting and don’t give up. Try all of them to see how they work for you and then start changing things around until you find ‘your’ way of packing.

Happy packing and puffing!

Be sure to see Tobacco Pipe Packing Methods - Part 2. It has the videos to show how each of these methods are done!

Tobacco Pipe Packing Methods - Part 2 (Videos)

 

 

 

10 Responses to “Tobacco Pipe Packing Methods - Part 1”

  1. Kevin said:

    Oh man, what a great post!

    “it is easier to tighten up the tobacco while smoking than it is to loosen it up”

    Yes! I finally figured that one out, lol.

    Sometimes I get a perfect pack and other times I mess it up. This article is super interesting and very helpful.

    I am going to keep this book-marked and try all of them.

    Thanks Bob.

  2. [...] am not going to repeat the written directions as you can read them in Tobacco Pipe Packing Methods – Part 1. I am just going to post the videos in this article so that you can see visual instructions that go [...]

  3. dgifford said:

    Thank you Sir!. Interesting observation…. when doing the Frank/Air/Air-Bob method, I find that if the tobacco is on the drier side of life, these methods gift you with a mouthful of bits and pieces on the draw test as the tobacco does not hold clump well (at least for me). I go for the two-step fill when my tobacco is a bit dry, or if I am in a hustle.

  4. [...] It easily crumbles and needs little to no rubbing out for filling your bowl with the simple "Three Step Method". It lights easily and stays lit with little effort. Rich billows of smoke and flavor are [...]

  5. dd951 said:

    I started using the air pocket method just last week, I really like it. I get A good pack and A good light

  6. randy931 said:

    I have been using the Frank method it is working for me was you get use to it.

    Thanks Bob

  7. [...] drying time needed. The cut of this blend is rough, coarse, and chunky. I loaded the pipe using the Three Step Method and proceeded to the charring [...]

  8. queensmessenger said:

    With the pipe in my mouth I proceed to fill and draw at the same time. This easilly lets me know if I am overpacking and I can get it perfect every time. However I sometimes do the simpler pack in one go system and can now automatically put the right pressure on the filling to make it draw properly. Practise makes perfect

  9. [...] Tobacco Pipes to Pipe Tobacco Blends A Few Pipe Lighter Reviews Flake Pipe Tobacco Preparation Tobacco Pipe Packing Methods - Part 1 Tobacco Pipe Packing Methods - Part 2 (Videos) Reading Between The Lines - Pipe Smoking Tips [...]

  10. Gilabert said:

    Je n aime pas Frank méthode qui envoie trop de nicotine mais bob le tabac reste léger et fin je ne sais pourquoi.
    -
    *[Translated]
    I don t like Frank method that sends too much nicotine tobacco bob but still light and thin I do not know why.

 

 

Most Popular Posts



  • Pipe Tobacco Storage
    :   By Bob Tate A lot of pipers wonder if and how they can store their pipe tobacco. There are ways to store your tobacco and it will last for years and if done properly, it will allow the ... 36 comment(s) | 77 view(s) per day


  • A Few Pipe Lighter Reviews
    :   By Bob Tate When it comes to lighting your pipe, there are always discussions about what is the best thing to use. There is the famous debate about lighters VS matches. Because whether ... 31 comment(s) | 37 view(s) per day


  • Flake Pipe Tobacco Preparation
    :   By Bob Tate Flakes are one of the ways that pipe tobacco is made. Flake tobacco is made by pressing tobacco under extreme pressure for a period of time forming a cube. The cube is then ... 23 comment(s) | 32 view(s) per day


  • English Blends and Latakia Blends - One and the Same?
    :   By Bob Tate Some of you may know from reading my articles, reviews, and from discussions in our forums, that I normally use the term ‘Latakia Blend(s)’ and not ‘English Blend(s)... 17 comment(s) | 31 view(s) per day


  • Tobacco Pipe Packing Methods - Part 1
    :   By Bob Tate [Editors Note: Be sure to read Part Two of this article, Tobacco Pipe Packing Methods - Part 2 (With Videos), to see instructional videos on how to perform these methods.] ... 10 comment(s) | 29 view(s) per day


  • How to Rehydrate Pipe Tobacco - Rehydrating Pipe Tobacco
    :   By Bob Tate If you store your pipe tobacco properly, it should not dry out. But I am sure that it has happened to us all at one time or another. We open a tin, pouch, or baggie to smoke... 16 comment(s) | 25 view(s) per day


  • Routine Tobacco Pipe Cleaning (With Videos)
    :   By Bob Tate *Editors Note: These cleaning instructions are for use on wood pipes such as Brair, Olive, Cherry, etc. It is not recommended to clean Meerschaum pipes using these instructions.... 27 comment(s) | 24 view(s) per day


  • Pipe Smoking Tips
    :   By Bob Tate When I first started smoking a pipe, I had no mentor to talk to and nobody to show me tips on how to make pipe smoking more enjoyable. I had to learn a lot on my own from re... 14 comment(s) | 20 view(s) per day


  • How to Ream a Tobacco Pipe
    :   By Bob Tate Although this article is ultimately going to explain and show how to ream your tobacco pipes, I thought that I would first talk a little bit about cake. After all, you won... 4 comment(s) | 20 view(s) per day


  • Dunhill Early Morning Pipe - Pipe Tobacco Reviews
    :   By Bob Tate *Editors Note/Correction: I have to make a correction to this review. After further investigation, I have found out from Orlik that this blend does contain Latakia. Here ... 15 comment(s) | 18 view(s) per day


  • Dunhill My Mixture 965 - Pipe Tobacco Reviews
    :   By Bob Tate The tin aroma of this blend is a strong, sweet and smoky tobacco smell with a light hint of spice to it. It smells very good. The moisture content is good for smoking right ... 5 comment(s) | 17 view(s) per day


  • Tobacco Pipe Packing Methods - Part 2 (Videos)
    :   By Bob Tate This is a companion piece to my article, Tobacco Pipe Packing Methods. I apologize that it took me so long to get this piece up, but here it is. It is the video tutorials on... 6 comment(s) | 17 view(s) per day


  • Interview with Greg Pease of G.L. Pease Tobacco - Part 1
    :   By Bob Tate Greg Pease is the owner of G.L. Pease, Intl. Greg began blending pipe tobacco over 30 years ago and in 1998 left his regular job of 18 years to pursue tobacco blending full ti... 10 comment(s) | 14 view(s) per day


  • Dedicating Tobacco Pipes to Pipe Tobacco Blends
    :   By Bob Tate To dedicate or not to dedicate? That is a question that is asked frequently by pipe smokers. Before I give my answer to this question, I would like to explain a few things. ... 14 comment(s) | 14 view(s) per day


  • The Mystery of Balkan Blends
    :   By Bob Tate Balkan Blend. That term is very mysterious. Is there really such a thing? If there is, what is it? What distinguishes a blend as a Balkan Blend? These and many other questio... 22 comment(s) | 13 view(s) per day


  • Reading Between The Lines - Pipe Smoking Tips
    :   By Bob Tate I would like to talk a little about the information that novice pipers will come across. The reason that I named this article “Reading Between the Lines”, is because I w... 15 comment(s) | 12 view(s) per day