I'm having a difficult time making my Thunderbird butane insert work.I use Vector fuel, clean the ignition point, and the fuel fill point and still the darn thing won't ignite until I snap the flint wheel a dozen times. What am I doing wrong?
Make Butane Lighters Work?
- Thread starter sparrowhawk
- Start date
.gif)
SmokingPipes.com Updates
Watch for Updates Twice a Week
PipesMagazine Approved Sponsor
Site Sponsors
PipesMagazine Approved Sponsor
PipesMagazine Approved Sponsor
PipesMagazine Approved Sponsor
PipesMagazine Approved Sponsor
- Status
I have the one with a piezoelectric spark. Works fine every time. Flint needs changing? Wheel misaligned?
Take one of the compressed air cans and blow out the nozzle of the lighter a bit. All it takes is to get a minute particle of ash or anything else in it and you have problems. May need to adjust the flame. What I've found most often is the need to bleed off the air. I bleed the chamber every time I refill.
A butane lighter with flame set too high won't light well, nor with it too low.
Have you bled it?
Have you bled it?
I believe you were asking the same thing last week and I was telling you about the new xikar bleeding tool. Get it. But yes if you bleed it and blow out the nozzle and tweek the flame ht and it still don't work ur sol..
- Status