Going (wal)nuts
- Thread starter unclearthur
- Start date
- Status
Thanks. Had to stop for the night . Needed a couple pain pills and trying to work of three lathes at the same time sucks! 8O
Yes it is. trying to mount a stem in the walnut is asking for disaster. It WILL split eventually. I am planning on the ball type stem I used for the short one on the Bursar pipe for this one. Sound OK?
Thanks. That was a very large block so I am doing another for Bob from it. Maybe a bulldog. Hound of The Baskervilles!
Mr. A.
I have a round 4inch x 3inch thick Black walnut stock sitting around.
Now I know what to do with it. Different shape though. The layout you drew
is so simple that I have over drawin the pipes I have already done.
You can bet your bottom dollar that my pipes do not even compaair to yours.
3 lathes !!! That would be a lot of beers to give up to buy. But you being single
you do not a produt manager.
Joe
I have a round 4inch x 3inch thick Black walnut stock sitting around.
Now I know what to do with it. Different shape though. The layout you drew
is so simple that I have over drawin the pipes I have already done.
You can bet your bottom dollar that my pipes do not even compaair to yours.
3 lathes !!! That would be a lot of beers to give up to buy. But you being single
you do not a produt manager.
Joe
- Status