.gif)
So, this is a first attempt at carving a pipe from scratch.
I'll post more photos as the project progresses
Started off with an 8" section of poplar 2 by 2.
Design (billiard) sketched out with a Sharpie.
Draught hole drilled first, using a 1/4" bit, eyeballing the angle and using a hand drill (I don't have a drill press).
Bowl drilled using a 1/2" spade bit, then widened using a Dremel with a sanding bit.
Draught hole meets the bowl at the bottom.
Still some shaping to do, and finishing. No plans yet for a stem.
Let me know your thoughts.
If it were me who was making it, I might do things differently. But the carver is my 10 year old son, and he has a mind of his own.
I'll post more photos as the project progresses
Started off with an 8" section of poplar 2 by 2.
Design (billiard) sketched out with a Sharpie.
Draught hole drilled first, using a 1/4" bit, eyeballing the angle and using a hand drill (I don't have a drill press).
Bowl drilled using a 1/2" spade bit, then widened using a Dremel with a sanding bit.
Draught hole meets the bowl at the bottom.
Still some shaping to do, and finishing. No plans yet for a stem.
Let me know your thoughts.
If it were me who was making it, I might do things differently. But the carver is my 10 year old son, and he has a mind of his own.
